Addressable Manual Call Point for W Series

An addressable manual call point allows to manually trigger the fire alarm system from a certain location in case occupants notice a fire before the system is activated.

The addressable manual call point of W Series is a non-addressable manual call point (MCP) connected to an addressable input-output module. Any non-addressable manual call points that meet the requirements of DSTU EN 54-11 can be used. It is recommended to choose a MCP with indicator.

If there is enough space in the MCP enclosure, the WM110 addressable I/O device (printed board covered by heat-shrink tubing) is fitted inside. Otherwise, the WM210 addressable I/O device in plastic housing is used, it can be connected to any convenient place within the fire alarm loop.

Features
Technical Data
Downloads

- Address range 1 – 125.
- Address setting via P-01 device programmer.
- Short circuit isolator built in the addressable I/O device.
- Remote LED option.
- Loop powered.

Addressable I/O Module Technical data

Supply voltage	17 … 28 V DC
Protocol voltage	5 … 9 V
Quiescent current:
– WM110	≤ 0,15 mA
– WM210	≤ 0,19 mA
SCI maximum series resistance, switch closed	≤13 Ω
Dimensions, mm:
– WM110	72 х 33
– WM210B	78 х 76 х 28
– WM210D	59 х 76 х 54,5
Operating temperature	-10 ºС to +65 ºС
Humidity	0 -95 % (no condensation or icing)
Average service life	10 years

Login or register to get access to full datasheets
Addressable Manual Call Point W Series (technical data brief) (424.72 KB)